Davis Square
The Davis Square end of Somerville is dense two- and three-family housing with rear porches and small yards. Renovations here fit the range into what used to be a pantry or back hall, where depth rather than width is the constraint.
What is different about working here.
Two- and three-family houses mean the kitchen is often on the first or second floor with a rear porch as the only realistic route in, and the appliance has to come through a door frame nobody measured before ordering. Where a range has been fitted into a former pantry, the depth is the constraint rather than the width, and a hood duct usually takes at least two turns before it reaches outside air.
The four repairs, from this postcode.
What it is like to hire us
4.9
★★★★★
The induction zone kept throwing an error and shutting off under load. The cooling fan beneath the glass was clogged with dust off the back hall. Cleaned, board reseated, and it has taken a full pot since.
Suki A. · Davis Square
★★★★★
Clicking carried on long after the flame caught. A cap was sitting slightly proud and shorting the spark. Ports cleaned, cap seated, silent since.
Renata B. · Davis Square
★★★★★
The blower was loud and yet moving almost no air at all. The duct runs up through the back porch wall and had a crushed elbow hidden behind the plaster where nobody would ever see it. He rerouted that last section and the kitchen is a different room now.
Sable M. · Davis Square
A visit in Davis Square.
Model number, what it is doing, and how the kitchen is reached. Most calls are half-diagnosed before anyone is dispatched.
Answered 24/7 · on site 8:00 am – 8:00 pm, seven days · flat $95 service call, credited against an approved repair
What the repair itself costs
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it. Ranges, not quotes — your figure is agreed before anything is taken apart.
- Igniter or spark module replacement
- $280 – $630
- Burner valve or orifice service
- $240 – $1,050
- Oven thermostat or sensor calibration
- $150 – $730
- Convection fan or motor
- $330 – $910
- Control board or touch panel
- $510 – $1,660
- Door hinge, glass or seal
- $210 – $1,000